If you have a small suitable screwdriver just see if you can tighten
them a bit, not too much pressure a finger and a thumb should be enough
to check if the screws are loose. With mine it was obvious when as soon
as I touched them.
IanW
Candace Lemarr wrote:
> Hey Ian....they seem ok...how would I know if one were lose? And then
> what could I do about it? This is an interesting question, as there does
> seem to be a bit of "play" in the mount/lens after it is locked into
> position. Meaning I can jiggle the lens from side to side if I try. Me
> thinks that's no good...
> Candace
>
> swisspace wrote:
>> I had problems with me E1 and focussing which turned out to a be a loose
>> mount, check the mount screws are not loose.
>>
>> IanW
>
>
> ==============================================
> List usage info: http://www.zuikoholic.com
> List nannies: olympusadmin@xxxxxxxxxx
> ==============================================
>
==============================================
List usage info: http://www.zuikoholic.com
List nannies: olympusadmin@xxxxxxxxxx
==============================================
|