You got it. But, with the 1 and 1N you still won't be able to do ceiling
bounce with the T32 when the camera is held vertically (or any bounce,
at all, with the T20) in auto mode, since the sensor is still on the
flash body, not the grip. Which was the question that brought all this
up to begin with, if I remember. You can do manual bounces with both.
If you are using a drive or winder, get the M Grip Cord.
Paul
>
> On Wed, 16 Sep 1998 13:19, Pauls0627@xxxxxxx wrote:
> >In a message dated 9/16/98 12:56:11 PM Eastern Daylight Time,
> >dlau@xxxxxxxxxxxxxxxx writes:
> >
> ><< Since I am new to all this fancy flash "group", I have some question about
> > the TTL Cord and Bounce Grip 2. Do I need anything else to connect the
> > flash/grip to the camera (i.e., another cable perhaps) or is the grip
> > complete all by itself?>>
> >
> >The grip, flash, and TTL cord are all you need.
>
> So let me see if I have this straight:
> 1. The Bounce Grip 2 comes with a built-in PC cord to connect to the
> camera, and it has a "plain" hot-shoe for the flash. This PC cord/hot-shoe
> combination will work with any camera (from OM-1 onward, and I'd
> assume any non-Olympus camera as well, as long as it has a PC socket),
> and any flash with a hot-shoe connection. But the flash can only be used
> in manual or "local auto" mode.
>
> 2. In order to use the TTL capability of the T32 flash off camera:
> For OM-2: I'll need a TTL Connector 3 which screws into the hot-shoe
> socket in place of the hot-shoe 3. I assume the Connector 3
> comes with a cord that plugs directly into the flash.
> For OM-2n: I'll need a TTL Connector 4 which screws into the hot-shoe
> socket in place of the hot-shoe 4. I assume the Connector 4
> comes with a cord that plugs directly into the flash.
> For OM-2s, OM-3*, OM-4*: I'll need a TTL cord that connects the camera
> directly to the flash.
> I'd assume that with any of these, i don't need a Bounce Grip 2, as the
> connection is direct from the camera to the flash and the hot-shoe (on
> the flash) is not used.
>
> 3. The TTL Connector 4 can also be used with the OM-1n, but it does not
> provide any additional capability over the PC connector except that
> the LED in the viewfinder lights up (i.e., the flash can only be used
> in manual or "local auto" mode).
>
> Do I have all the correct assumptions, especially the ones under #2 above.
> I'd appreciate any additional clarifications anyone can provide. Thanks.
> -Dan
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|