My vote would go for IPS Weld-On 3
I have edge cemented 1mm thick acrylic & fixed innumerable plastic toys
with this stuff...
TAP Plastics carry this also...
davidt
On Sun, Jul 13, 2008 at 06:03:03PM -0400, NSURIT@xxxxxxx wrote:
>
> I have an archival print washer that has a tiny leak. It took twenty four
> hours for 1/3 of the water to leak out and ultimately it will sit in a sink,
> so the leak won't matter. This kind of thing makes me crazy, so I want to
> stop the leak. What suggestions on products available in the USA could be
> used
> to potentially stop a leak where two pieces of plexiglass are joined. It
> would be nice if when the glue was applied the resulting patch was not butt
> ugly.
> THIA, <[B^) Bill Barber
>
>
>
> **************Get the scoop on last night's hottest shows and the live music
> scene in your area - Check out TourTracker.com!
> (http://www.tourtracker.com?NCID=aolmus00050000000112)
>
>
> ==============================================
> List usage info: http://www.zuikoholic.com
> List nannies: olympusadmin@xxxxxxxxxx
> ==============================================
>
==============================================
List usage info: http://www.zuikoholic.com
List nannies: olympusadmin@xxxxxxxxxx
==============================================
|