Hi all;
Thank's a lot for these good advices.
I will try to charge it 12 hours. if it do not work i will try to
replace the nicads.
Regards Loïc;
-----------------------------
Loïc Courtais, Paris 20ème.
http://www.ifrance.com/multispot
Le 19 janv. 05, à 14:37, John Hermanson a écrit :
>
> A full charge could take 12 hours. Problem could easily be that
> nicads are
> old and will no longer take a charge, in which case cluster replacement
> would be required.
>
> John Hermanson
> Camtech Photo Services, Inc.
> 21 South Lane, Huntington, NY, 11743-4714,
> 631-424-2121, www.zuiko.com
> Olympus OM Service since 1977
> <:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:-:>
> ----- Original Message -----
> From: "asud journal" <asudjournal@xxxxxxxxxxxxxxxx>
> To: <olympus@xxxxxxxxxx>
> Sent: Tuesday, January 18, 2005 11:30 AM
> Subject: [OM] Re: Motor drive 2 battery replacement?
>
>
>>
>> When do the ligth check it is ok .
>> But after the first full charge of the M15v i have done, about 5
>> hours.
>> It seems that the capacity of the nicad batts are to low.
>> After shooting three rolls the MD2 speed is slowered.
>> When i shot in one time a whole 24 frames roll in sequence the speed
>> of
>> the MD2 is slowered since the 12th frame to the 24th.
>> Does it caused by a dammaged nicad battery in the M15v which cause a
>> voltage fall down?
>> thank's Loïc
>> Le 18 janv. 05, à 16:33, Piers Hemy a écrit :
>>
>>>
>>> The NiCad Control Pack has a small red check light on the left rear.
>>> Ater
>>> charging, it should light when the check button beside it is pressed.
>>> If it
>>> does not light, the battery has not charged, and that is when you
>>> have
>>> to
>>> replace it!
>>>
>>> €212 is about $275. That seems to me a good price for MD2 and M18V
>>> (which
>>> is a very practical power source for the MD2). The two M15V with
>>> charger
>>> were therefore free!
>>>
>>> --
>>> Piers
>>>
>>> -----Original Message-----
>>> From: olympus-owner@xxxxxxxxxx [mailto:olympus-owner@xxxxxxxxxx] On
>>> Behalf
>>> Of asud journal
>>> Sent: 18 January 2005 13:42
>>> To: olympus@xxxxxxxxxx
>>> Subject: [OM] Motor drive 2 battery replacement?
>>>
>>>
>>> Hi,
>>> I went to buy a motor drive 2 with the charger 1, 2 m 15v control
>>> pack
>>> 1&2 and a m 18v control grip 1 for 212€.
>>> It is in good working condition but i would to know how to test the
>>> batterys
>>> and when do i have to replace it?
>>> Loïc
>>>
>>> -------------------------------
>>>
>>> Loïc Courtais, Paris
>>>
>>> http://www.ifrance.com/multispot
>>> ==============================================
>>> List usage info: http://www.zuikoholic.com
>>> List nannies: olympusadmin@xxxxxxxxxx
>>> ==============================================
>>>
>>> ==============================================
>>> List usage info: http://www.zuikoholic.com
>>> List nannies: olympusadmin@xxxxxxxxxx
>>> ==============================================
>>>
>>
>> ==============================================
>> List usage info: http://www.zuikoholic.com
>> List nannies: olympusadmin@xxxxxxxxxx
>> ==============================================
>>
>
>
>
> ==============================================
> List usage info: http://www.zuikoholic.com
> List nannies: olympusadmin@xxxxxxxxxx
> ==============================================
>
==============================================
List usage info: http://www.zuikoholic.com
List nannies: olympusadmin@xxxxxxxxxx
==============================================
|