I use either Hobscos "Goo" (sold in hobby stores)< or Pliobond which used to
be made by Goodyear. I put a "Microtip" extension on the tube which will
reach into the slot of the camera body and lay down a very fine thin layer of
glue.
John
Joel Wilcox wrote:
> At 05:36 PM 8/4/1998 -0400, you wrote:
> >I really must say that not gluing the foam in the body may make
> installation easier up
> >front, but is not the proper way to do it, and later, in a few years, when
> the foam
> >developes a little surface tackiness, the foam may start pulling out of
> the slots.
> >Hey, I sell the pre cut foam too, but the installer is completely on his
> own.
> >
> >John
> >Camtech
> >
> What's your favorite glue for this, John?
>
> Joel
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|