Olympus-OM
[Top] [All Lists]

[OM] Re: OT Help needed on Nikon scanner

Subject: [OM] Re: OT Help needed on Nikon scanner
From: Chuck Norcutt <chucknorcutt@xxxxxxxxxxxxxxxx>
Date: Wed, 02 Jan 2008 09:31:18 -0500
I don't know anything about your scanner but when I looked at your 
blurred image my first thought was mis-focus, not mechanically caused 
blurring.  I'm not sure I can tell the difference but if you consider 
both situations it may assist with the analysis of the cause.

Chuck Norcutt

Mike Bloor wrote:
> Can anyone help with a problem with my Nikon LS30 scanner ?
> 
> I used the scanner yesterday for the first time in about six 
> months.  I had been waiting until I found time to clean the mirror, 
> which I thought was affecting the quality of scans.  Because of 
> difficulty with one jammed screw, the only disassembly I did was to 
> take off the side and front covers.  I then cleaned the dust off the 
> mirror using moistened lens tissues.
> 
> I also - and this may have been a mistake - wiped some dust off the 
> two steel rails on which the mirror/lens assembly runs.  In doing so 
> I wonder if I have removed lubricant.
> 
> On using the scanner again, all but four of the frames in the first 
> film were blurred.  The effect is similar to camera shake.  I then 
> tried repeated scans of one frame, which certainly did not look 
> blurred to the naked eye.  I used both the SR20 motorised film strip 
> holder and the FH2 film strip holder, in case the motorised version 
> that I had started with was causing problems.  There was no difference there.
> 
> What did make a difference was whether I used the scanner vertically 
> or horizontally.  In the past I have always used it 
> vertically.  Having learnt the difference it can make to the amount 
> of dust collecting on the mirror, I decided to use it horizontally 
> from now on.  In my tests, used horizontally, the scans were almost 
> always blurred.  Used vertically, they are blurred about 60% of the time.
> 
> You can see examples at http://www.vyuze.com/v/blurred.jpg and 
> http://www.vyuze.com/v/ok.jpg
> 
> Any suggestions on where to go from here would be gratefully received.
> 
> OM connection - shot was taken with am OM4 and 100/2.8.
> 
> 
> Mike Bloor 
> 
> 
> ==============================================
> List usage info:     http://www.zuikoholic.com
> List nannies:        olympusadmin@xxxxxxxxxx
> ==============================================
> 
> 
> 

==============================================
List usage info:     http://www.zuikoholic.com
List nannies:        olympusadmin@xxxxxxxxxx
==============================================

<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz