From: "John Petrush" <petrush@xxxxxxxxxxxxx>
Nodding agreement with Hans to scan both pieces seperately...
I haven't had very good luck with this technique, but possibly
because I'm missing something. I always end up spending lots of time
in arbitrary rotate to get them to line up, and then the edges don't
match, colors are slightly different, etc.
If you go this route, you might want to scan both halves at the same
time, but separated enough to be able to cut them apart in Photoshop
for re-aligning, and carefully make sure the two are squared on the
platen guide of the scanner. That way, as many of the variables of
scanning as possible will be the same for both halves.
: Jan Steinman <mailto:jans@xxxxxxxxxxx>
: 19280 Rydman Court, West Linn, OR 97068-1331 USA
: +1.503.635.3229
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|