Thanks, I have been unable to verify the thread size and direction....I have
a Shoe1 (fix) and an OM1 and I also have a Connector 3 but do not have an
OM2 so I have not been able to try the Shoe 1 (fix) on an OM2 to see if they
are the same thread..
Bruce Kolber
St. Petersburg, FL 33715
USA
----- Original Message -----
From: "C.H.Ling" <chling@xxxxxxxxxxxx>
To: <olympus@xxxxxxxxxxxxxxx>
Sent: Tuesday, May 08, 2001 8:34 AM
Subject: Re: [OM] auto connector type 3
> I think the OM-1 has different screw-in direction for both hot shoe and
TTL
> connector (may be there was no TTL connector designed for OM-1). As there
is
> no LED inside the finder, you better use a regular cord and a normal
"remote
> shoe" to connect your T-series flash.
>
> C.H.Ling
>
> ----- Original Message -----
> From: "Bruce Kolber" <bkolber@xxxxxxxxxxxxxxx>
> To: <olympus@xxxxxxxxxxxxxxx>
> Sent: Tuesday, May 08, 2001 8:00 AM
> Subject: [OM] auto connector type 3
>
>
> Does the Auto Connector Type 3 fit an OM1 (not OM1n) if the secondary pin
is
> removed?
>
> Bruce Kolber
> St. Petersburg, FL 33715
> USA
>
>
>
> < This message was delivered via the Olympus Mailing List >
> < For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
> < Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
>
< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >
|