Olympus-OM
[Top] [All Lists]

Re:[OM]XA clamshell cover

Subject: Re:[OM]XA clamshell cover
From: "Ben Poels" <poelsb@xxxxxxxxxxxxxxx>
Date: Fri, 19 Feb 1999 15:38:43 -0500
Thanks John and Jay,

That is exactly my problem. It was not "clicking" into
place and where is no bearing. So where exactly does
this little bearing go? How big is it in diameter and
length? And how do you keep it in place when putting the
cover back on - I don't see any groove to hold it.

Thanks,

Ben


>On Thu, Feb 18, 1999 at 03:39:31PM -0500, John Hermanson wrote:
>> Don't lose cylindrical bearing that provides the "click".
>
>...and if you do, you can cut a screw of suitable size to the proper
>length
>(without the head) to replace it...of the 3 XAs I've acquired, two >have
been
>missing the bearing. That little bit is important to hold the cover >fully
>open against the shutter enable switch; if it's not there, your XA >will be
>hard to make work consistently.



< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >


<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz