Olympus-OM
[Top] [All Lists]

Re: [OM] OM1 wiring

Subject: Re: [OM] OM1 wiring
From: John Hermanson <omtech@xxxxxxxxx>
Date: Wed, 11 Nov 1998 12:28:36 -0500
If it broke off at the rewind  side of the camera, it is sildered to the tiny
tab that goes into the switch.

John

Jay Maynard wrote:

> I got industrious this evening and removed the foan between the hot shoe
> bracket and pentaprism on my OM-1. Then I had to go back in and replace the
> pentaprism because i broke it when putting the top cover on. (Argh.) In the
> process of all that, I broke the white wire that goes across in front of the
> pentaprism off where it attaches at the left side of the camera.
> Unfortunately, I didn't notice where it had been hooked up. Where should I
> connect it? I can solder quite well, thankfully...I tried the pad at the
> front right of the little circuit board, but the meter's not working, so I
> must have either gotten it wrong or broken something else. (Maitani-san, why
> didn't you use a little bit bigger wire?)
>




< This message was delivered via the Olympus Mailing List >
< For questions, mailto:owner-olympus@xxxxxxxxxxxxxxx >
< Web Page: http://Zuiko.sls.bc.ca/swright/olympuslist.html >


<Prev in Thread] Current Thread [Next in Thread>
Sponsored by Tako
Impressum | Datenschutz